OneCNCXR5 30.72 contains post adjustment for C Axis OneCNCXR5 Lathe
Some machines and Siemens lathe control in particular does not like to have 0 and 360 degree at the same point so there is now a setting in the post for 0-360 rotational of the C axis where after 359 degrees the next becomes 0 Zero instead of 360 degrees.

OneCNCXR5 30.72 contains post adjustment supporting X Y scale factor in Tool Change
When using -Y or -X in the post scale factor to reverse the direction of travel in the post the X and Y was was not supported in the Tool Change format. This change now supports the reversal in the tool change format.

OneCNCXR5 30.72 contains adjustments for Mill Profile
Adjustments were made to mill profile to better handle open shape profiles when the first and or last entity is an arc.

OneCNCXR5 30.72 contains adjustments for Z level Finish
There was an adjustment made to Z level finish because it was found some users were using End Mills as finish tools instead of Ball or Bull mill tools for finishing 3D shaped parts. This enhancement assists this use.

OneCNCXR5 Mill Expert and Mill Professional HS Z Level Rough
An adjustment was made to HS Z level rough to better handle bad models. In the past if the model was bad and there was a problem in processing the tool path it was recommended that the model to be broken to surfaces. This adjustment assists this and it is now less likely to have to break the model to individual surfaces.